Access Lamp - Sony UMC-S3C Technical Manual

f Image sensor position mark
The mark describes the position on the image sensor.
Use the position of this line to measure the distance from
the camera to objects correctly.
g Access lamp
Flashes while reading/writing on the SD memory card.
Do not remove the SD memory card or power plug, when
the access lamp is on.
Otherwise, the data in the SD memory card may be
damaged.
h POWER (power) indicator (green)
Lights up green when the camera is operating normally.
i Lens release button
To remove lens, rotate the lens by pressing the button.
When you mount the lens, do not press the button.
j Mount index
k !
12 V (DC power input) terminal
Connects to DC 12 V power supply.
For details, see Connection to the power supply on page 8.
To turn off the camera, control the camera via the I/O
terminal or multi/micro USB terminal.
l I/O terminal
Can control the external camera.
For details, see Connection to an I/O terminal on page 8.
m HDMI connector (Type D)
Connect a commercial HDMI cable.
n Multi / Micro USB terminal
You can connect devices which support micro USB
standards to this terminal to control the camera from
external devices.
Notes
• Do not wire the cable routed outdoors, when qa, qd is
connected.
• To wire indoors, the cable should be shorter than 30 m
for qa, qd.
• The cable should be shorter than 3 m for qf.
• When connected to qd, qf, it is recommended to secure
the cable to prevent disconnection from the camera due
to its weight or from external force.
4