HoMedics ag-3500TL Instruction Manual page 4

2. assemble Chair Base
• Attach both crossbars (Figure 2A) to the right hand armrest, matching
Figure 6
corresponding numbers, and insert large bolts and washers into bottom
bar only. tighten partially with Allen wrench. See Figure 2B.
• Attach both crossbars to left side armrest, matching the corresponding
letters. slide together, and stand base upright. See Figure 3.
• Insert large bolts into bottom bar only and tighten partially with Allen
wrench.
Note: Other bolts to be inserted later to allow extra movement of
frame during assembly.
Figure 7
3. attach Back Frame to Base
• Slide the back of the chair into the frame with the straps
facing the chair. See Figure 4.
• Align the back with the pre-attached bolts to the frame.
Figure 8
• From the back side, place washer and screw on caps/nuts to
secure Back frame to Chair Base. Use open end wrench to tighten
partially. See Figures 5A and 5B.
6
4. attach Seat/Leg Frame to Base
• Flip the chair on it's back and slide the seat in place. Place into frame
with the straps facing the back of the chair. See Figure 6.
• Align the Seat with pre-attached bolts.
Figure 9
• From the bottom side, add washer and screw on caps/nuts to secure the
Seat frame to chair base. Use open end wrench to tighten partially.
See Figure 7.
Figure 10
• squeeze frame together and insert remaining large bolts into the cross
bar under the seat and tighten partially with allen wrench.
• flip chair on its side and insert remaining large bolts into the cross bar on
the back of the base and tighten partially.
F i g ur e 1 1
• Stand chair upright and adjust so the base is level. completely tighten all
caps/nuts and bolts. See Figure 8.
Figure 12
5. attach Massage Cushion
• Slide the pocket at the top of the massage mat over the top of the back
frame. See Figure 9.
Figure 13B
Figure 13A
7