Asus Prime H270-Plus User Manual page 14

Table of Contents

Advertisement

System panel connector (20-3 pin F_PANEL)
This connector supports several chassis-mounted
functions.
System power LED (4-pin +PWR_LED-)
This 4-pin connector is for the system power LED.
Connect the chassis power LED cable to this
connector. The system power LED lights up when
you turn on the system power, and blinks when
the system is in sleep mode.
Hard disk drive activity LED (2-pin +HDD_LED-)
This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity
LED cable to this connector. The HDD LED lights up or flashes when data is
read from or written to the HDD.
System warning speaker (4-pin SPEAKER)
This 4-pin connector is for the chassis-mounted system warning speaker.
The speaker allows you to hear system beeps and warnings.
ATX power button/soft-off button (2-pin PWR_SW)
This connector is for the system power button. Pressing the power button
turns the system on or puts the system in sleep or soft-off mode depending
on the operating system settings. Pressing the power switch for more than
four seconds while the system is ON turns the system OFF.
Reset button (2-pin RESET)
This 2-pin connector is for the chassis-mounted reset button for system
reboot without turning off the system power.
Chassis intrusion header (2-pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
USB 2.0 connectors (10-1 pin USB1112, USB1314)
Connect a USB module cable to any of these
connectors, then install the module to a slot opening at
the back of the system chassis. These USB connectors
comply with USB 2.0 specifications and supports up to
480Mbps connection speed.
1-5
PANEL
+PWR_LED-
SPEAKER
PWR_SW
CHASSIS
PIN 1
+HDD_LED-
RESET
+PWR_LED-
* Requires an ATX power supply
USB1112
USB1314
PIN 1
PIN 1
ASUS PRIME H270-PLUS

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents