Motorola GP Series Detailed Service Manual page 120

1-8
5.0 Receiver (for ATEX specified models)
Antenna
Pin Diode
Antenna
Switch
RF Jack
5.1 Receiver Front-End
(Refer to UHF Receiver Front End Schematic Diagram on page 7B-79 and UHF Transmitter
Schematic Diagram on page 7B-84)
The RF signal is received by the antenna and applied to a low-pass filter. For UHF, the filter consists
of L103, C131, C139, L101, L102, C102, C103, C104. The filtered RF signal is passed through the
antenna switch. The antenna switch circuit consists of two PIN diodes(CR101 and CR102) and a pi
network (C106, L104 and C107).The signal is then applied to a varactor tuned bandpass filter. The
UHF bandpass filter comprises of L301, L302, C302, C303, C304, CR301 and CR302. The
bandpass filter is tuned by applying a control voltage to the varactor diodes(CR301 and CR302) in the
filter.
The bandpass filter is electronically tuned by the DACRx from IC404 which is controlled by the
microprocessor. Depending on the carrier frequency, the DACRx will supply the tuned voltage to the
varactor diodes in the filter. Wideband operation of the filter is achieved by shifting the bandpass filter
across the band.
The output of the bandpass filter is coupled to the RF amplifier transistor Q301 via C307. After being
amplified by the RF amplifier, the RF signal is further filtered by a second varactor tuned bandpass
filter, consisting of L306, L307, C313, C317, CR304 and CR305.
Both the pre and post-RF amplifier varactor tuned filters have similar responses. The 3 dB bandwidth
of the filter is about 50 MHz. This enables the filters to be electronically controlled by using a single
control voltage which is DACRx .
Varactor
RF Amp
Tuned Filter
Control Voltage
from ASFIC
Demodulator
Recovered Audio
RSSI
Figure 1-4: UHF Receiver Block Diagram
Varactor
Tuned Filter
First LO
from VCO
Limiter
THEORY OF OPERATION
Crystal
Mixer
Filter
U301
455kHz
Filter
Second LO
IF Amp