Honeywell Touchpoint Plus Technical Handbook page 94

MAN0984_Iss 2_06/15
Parameter Name
Default Range
Detector Name
Formula Gas Name
Gas Name
Gas Over Range Limit
Gas Type
Gas Under Range Limit
Gas Unit
Inhibit Timeout
Lower Zero Dead Band
Max Range
Min Range
Resolution
Sensor Name
Signal Fault Max
Signal Fault Min
Configurable Parameter Reference Guide
Parameter Description
Full scale range
Detector name
Formula for the target measuring gas
Target gas name
Over-range gas concentration limit. This parameter is used to generate
over-range warning.
Toxic (0), O2 (1), Flammable (2)
Set automatically by Gas Type
Negative reading limit
Measurement unit Strings:
%, ppm, %LEL, %VOL, mA
Inhibit timeout in minutes. 0 means permanent inhibit
Lower deadband range. The gas concentration within the deadband
limit will be suppressed to default base concentration. I.e. if the gas
concentration is between the (default base concentration - lower
deadband) and (default base concentration + upper deadband), then
the reading will be the default base concentration.
Maximum configurable measuring range
Minimum configurable measuring range
Index of display resolution for gas relevant parameters
Sensor name consists of gas name, full scale range and measurement
unit.
Upper mA input signal range to detect the fault reported by the detector.
Lower mA input signal range to detect the fault reported by the detector.
Applies to Read/Write
All
All
All
All
All
All
All
All
All
All
All
All
All
All
mA sensor
only
mA sensor
only
88
Technical Handbook
Default Measurement
Value units
R/W conc.
R/W per detector n/a
R per target gas n/a
R/W per target gas n/a
R/W 110 %FSD conc.
R/W per target gas n/a
R/W -7 %FSD conc.
R per target gas n/a
R/W 10 minutes
R/W -2 %FSD conc.
R conc.
R conc.
R/W per target gas n/a
R per target gas n/a
R/W 1.1 mA
R/W 0 mA
Touchpoint Plus