Fluke 9150 User Manual page 37

Press "SET" to edit the program soak time.

Use "UP", "DOWN", and "SET" to adjust the program soak time. This value can
be any integer from 0 to 14400. This time is the minutes the program set-point
maintains after the temperature of the furnace has settled and before proceeding
to the next set-point. Each digit flashes individually to indicate that it can be
adjusted.

Press "SET" to save the new soak-time value or "EXIT" to discard changes
The next value to edit is the program scan rate. This value is ignored if scan is
not enabled for the unit (See Section 8.3.1).

Press "SET" to edit the program scan rate.
 
Use "UP" and "DOWN" to adjust the program scan rate.
 
Press "SET" to save the new scan rate value or "EXIT" to discard changes.
After "SET" is pressed the controller advances to the next program point or, if
there are no more program points to edit, exits to the Program Function Menu.
Repeat the above steps to edit any program point.
Find Quality Products Online at:
Edit program point soak time
Current program point soak time
Program point 4 soak time set for 200 minutes
Accept the program point soak time
Program point 4 scan rate
Edit the program point scan rate
Current program point 4 scan rate
New program point 4 scan rate
Accept the program point scan rate
GlobalTestSupply
www.
Controller Operation
8.4 Ramp and Soak Program
.com
sales@GlobalTestSupply.com
8
8-7