Table of Contents
Advertisement
4 Press Play to start the show. During playback you can use the PAUSE button to
break the show - press PAUSE again to continue playback. The show will loop
continuously until stopped.
5 Press STOP to end.
D M X M O N I T O R
The DMX monitor displays DMX information in real time.
The second line of the display shows:
Id
Ch
Re
The lower lines show the DMX channels from 0 to 512 in four columns (0-3. 4- 7,
8-11, and so on). Each row displays the DMX values of four DMX channels. The
column to the left indicates the ID of the first of the four DMX channels that are
displayed in the respective row.
You can use the ↑ and ↓ buttons to scroll to a specific channel.
For each channel the monitor displays its current DMX value from 0 to 255.
C O N T R O L
The control menu is used to set and use control overrides such as lamp on, lamp off,
dim, and also to set the assignable faders on the LightCorder.
Perfor ming a lamp on command
This function can be used to issue DMX lamp on instructions from the LightCorder
provided that these have first been configured (see "Teaching lamp on commands"
on page 15).
To issue a lamp on command:
14
An identifier corresponding to the mode that the controller is using
The number of channels being received
The frequency, in hertz, at which the controller is transmitting
Advanced mode
Advertisement
Table of Contents
