Installing The Unit (In-Dash Mounting); When Installing Without The Mounting Sleeve; How To Remove The Unit; Part List For Installation - Kenwood KMM-BT518HD Instruction Manual

INSTALLATION/CONNECTION

Installing the unit (in-dash mounting)

Orientate the trim plate
as illustrated before
fitting.

When installing without the mounting sleeve

1 Remove the mounting sleeve and trim plate from the unit.
2 Align the holes in the unit (on both sides) with the vehicle mounting bracket and
secure the unit with screws (supplied/commercially available).
Use only the specified screws. Using wrong screws might damage the unit.

How to remove the unit

1 Detach the faceplate.
2 Fit the catch pin on the extraction keys
into the holes on both sides of the trim
plate, then pull it out.
3 Insert the extraction keys deeply into the
slots on each side, then follow the arrows
as shown on the illustration.
Do the required wiring.
( 36, 37)
Hook on the top side
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
For
Dashboard of
your car
For /
/

Part list for installation

(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
For For
(F) Screws (supplied for
ENGLISH
/
/
)
35