Test Run From Remote Controller - Fujitsu AUXB04GALH Service Manual

1-4-2 Test Run From Remote Controller

1. Standard wired remote controller
Stop the indoor unit. Push the
button simultaneously for more than two seconds.
The air conditioner will start to conduct a test run and "
the remote controller display.
However, the , setting button does not have function,
but all other buttons, displays, and protection functions will operate.
Perform the test operation for 60 minutes.
To stop test run, push the START / STOP button of the standard wired remote
controller.
For the operation method, refer to the operating manual and perform operation
check.
Check that there are no abnormal sounds or vibration sounds during test run
operation.
2. Standard wireless remote controller
Short two metal contacts under the battery compartment lid, while the air conditioner is running.
To stop test run operation, push
remote controller.
When the air conditioner is being test run, the OPERATION
and TIMER lamps of indoor unit flash slowly at the same time.
3. Simple remote controller
Stop the indoor and outdoor units. Push the remote controller
simultaneously for more than three seconds. The air conditioner will start to conduct a test
run and " " will display on the temperature display.
However the setting button does not have function but all other buttons,
displays and protection functions will operate.
To stop test running press the
For the operation method refer to the operating manual and perform operation check.
Check that there are no abnormal sounds or vibration sounds during test run operation.
button and
" will display on
button of the wireless
button of the simple remote controller.
button and button
01-14
UTY - RNK
SET TEMP .
START / STOP
FAN
TIMER MODE DAY
DA Y OFF
CLOCK ADJUST
SET BACK
TIMER DELETE TIMER SET
UTY - LNH
START/STOP button
MODE
OFF
Test run button
ECONOMY
FIL TER RESET
SET
TEMP .
SLEEP
TIMER
TIMER MODE
CLOCK TEST
ADJUST RUN
UTY - RSK
MODE
ON
FAN
SET
SET
SWING
RESET
SET