Maintenance And Servicing - CEN-TECH 200 watt continuous Owner's Manual & Safety Instructions

Maintenance and Servicing

Procedures not specifically explained in this manual
must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that all loads are disconnected from the Inverter, the Power Button
is in the off-position and the cables are disconnected from power
source before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
1. BEFORE EACH USE, inspect the
general condition of the tool. Check for:
• loose hardware,
• misalignment or binding
of moving parts,
• damaged cord/electrical wiring,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
AFTER USE, wipe external surfaces
2.
of the tool with clean cloth.
Item 66967
For technical questions, please call 1-888-866-5797.
3. Maintain batteries according to
manufacturer's instructions.
Check electrolyte level on all batteries
after charging and refill as needed.
Charge batteries according to
manufacturer's recommendations
ONLY; incorrect charging may cause
battery damage or explosion.
WARNING! TO PREVENT
SERIOUS INJURY AND DEATH
FROM ELECTRIC SHOCK:
DO NOT OPEN HOUSING!
Contains no user-serviceable parts.
Internal parts may be electrified, even
with unit off and power disconnected.
4. Internal electronic components must
be disposed of properly or recycled.
Page 11