Default Gateway: 192.168.42.1
–
Click OK and Close to exit the dialog box.
Step 9
For Mac
The exact steps depend on your operating system version.
Launch the Apple menu and choose System Preferences.
Step 1
Click Network.
Step 2
Click the lock icon to allow changes.
Step 3
Select the Ethernet network configuration with the
Step 4
green icon. This is your active connection. Then click
Advanced.
Click the TCP/IP tab and from Ethernet settings,
Step 5
choose Manually from the drop-down list.
Enter the following changes:
Step 6
IP Address: 192.168.42.43
–
Subnet Mask: 255.255.255.0
–
Router: 192.168.42.1
–
Click OK.
Step 7
8
Connect to the Appliance
The Cisco C690 appliances have five gigabit network ports and
a Management port, as shown in the figure on the following
page . At least one static IP address is required to send and
receive email.
You can receive and deliver email from a single connection to
either network port if your network topology dictates it. Two IP
addresses can be configured on one network interface.
Or, you can connect the Data 1 network port to your public
network and connect the Data 2 network port to your private
network.
7