Table of Contents
Advertisement
This is the configuration information that has been
collected:
SNMP Interface = "public"@10.1.2.100
User Account setup = admin
Password = ********
Out-of-band IP address = DHCP
VLAN1 Router Interface IP = 10.1.1.200 255.255.255.0
Default Gateway = 10.1.1.1
Step 6:
If the information is correct, please enter (Y) to
save the configuration and copy the settings to the
start-up configuration file. If the information is
incorrect, enter (N) to discard the configuration and
restart the wizard: [Y/N] y
Thank you for using the Dell Easy Setup Wizard. You
will now enter CLI mode.
Applying Interface configuration, please wait...
Next Steps
After completing the initial configuration described in this section, you can connect the OOB port to your management network for out-of-
band remote management, or you can connect any of the front-panel switch ports to your production network for in-band remote
management.
If you specified DHCP for the OOB or VLAN 1 management interface IP address, the interface acquires its IP address from a DHCP server
on the network. To discover the dynamically assigned IP address, use the console port connection to issue the following commands:
•
For the OOB interface, enter show ip interface out-of-band.
•
For the VLAN 1 routing interface, enter show ip interface.
To access the Dell OpenManage Switch Administrator interface, enter the OOB management interface IP address into the address field of
a web browser. For remote management access to the CLI, enter the VLAN 1 management interface IP address into a Telnet or SSH
client. Alternatively, you can continue to use the console port for local CLI access to the switch.
Your N30xx switch supports basic switching features such as VLANs and spanning tree protocol. The N30xx switches also support
advanced Layer 3 features such as dynamic routing and multicast. Use the web-based management interface or the CLI to configure the
features your network requires. For information about how to configure the switch features, see the User's Configuration Guide or CLI
Reference Guide available on the support site: dell.com/support/manuals.
Performing Initial Configuration on Dell Networking OS
9.11(0.0)
Before proceeding, ensure that the C9010 switch runs Dell Networking OS version 9.11(0.0) or later.
The following section explains the procedure to set up an N30xx switch if it runs the Dell Networking OS version 9.11(0.0) or later:
To complete the hardware installation, install the system in a rack, attach an uplink cable to a parent C9010 switch, set up an N30xx stack
if required, and power on the port extender.
To provision an N30xx system, configure basic software settings from the C9010 console either before or after you connect the N30xx to
a C9010. For example, you can preconfigure software settings to download from the parent C9010 after you power on the N30xx.
Perform provisioning preconfigured N30xx settings using a discovery and authentication process through a port-channel interface on the
C9010.
Starting and Configuring the N30xx System
45
Advertisement
Table of Contents
