Electrolux T5190LE Service Manual page 81

12:18 REDISTRIBUTION OF LOAD NEEDED
The error code is shown if the input VACUUM has deactive several times during program run and the function to han-
dle vacuum error during program run has failed to recreate vacuum in the machine. The error code is reset from the
control system by a short press on the control knob/start button. A long press on the control knob/start button will
make the control system reset and ongoing program will be ended.
The error code can be trigged if:
• The load is blocking the airflow.
Check the load and redistribute it in the drum.
12:253 JUMPER 1
The error code is shown if input JUMPER 1 is not activated.
Jumpers are a by-pass of inputs not used in the machine. How many jumpers used is depending on configuration.
When the jumper is restored the error code is automatically reset and the ongoing program will continue. A long
press on the control knob/start button will make the control system reset and ongoing program will be ended.
Recommended actions:
Check the harness, connectors and functions by reading the electrical schematic and by using the SHOW INPUTS
menu when the machine is in service mode.
12:254 JUMPER 2
The error code is shown if input JUMPER 2 is not activated.
Jumpers are a by-pass of input not used in the machine. How many jumpers used is depending on configuration.
When the jumper is restored the error code is automatically reset and the ongoing program will continue. A long
press on the control knob/start button will make the control system reset and ongoing program will be ended.
Recommended actions:
1. Check the harness, connectors and functions by reading the electrical schematic and by using the SHOW INPUTS
menu when the machine is in service mode.
12:255 JUMPER 3
The error code is shown if input JUMPER 3 is not activated.
Jumpers are a by-pass of input not used in the machine. How many jumpers used is depending on configuration.
When the jumper is restored the error code is automatically reset and the ongoing program will continue. A long
press on the control knob/start button will make the control system reset and ongoing program will be ended.
Recommended actions:
1. Check the harness, connectors and functions by reading the electrical schematic and by using the SHOW INPUTS
menu when the machine is in service mode.
Service Manual
81