Electrolux T5190LE Service Manual page 47

Service Manual
47
Cut loose the rear sealing from the inner sealing plate.
Put glue on the inner sealing plate and fasten the new rear sealing on the inner sealing plate. The rough side shall be
fastened to the glue.
fig.7970
Remount the outer sealing plate and fasten the screws.
Remount the drum.
Remount the supporting rail.
Remount the control panel.
Remount the RMC with arm.
Fasten the bolt and the washer and remount the bearing house. Use tightening torque 20 Nm ± 3 Nm.
On machines with RMC; pull the RMC flange back in position and tighten the screw. Use tightening torque 5 Nm ±
0.5 Nm.
Fasten the belt and make sure the belt is in position.
Remount the RMC with arm above the drum.
Remount the rear panel and the top panel.
Connect the door switch cable and remount the front panel.
Remount the filter.
Remount the door.