Assigning Ip Addresses - D-Link DGS-1210/ME Series Hardware Installation Manual

DGS-1210/ME series Metro Ethernet Switch Hardware Installation Guide
save all your configuration changes in nonvolatile storage, you must
use the save command to copy the running configuration file to the
startup configuration.

Assigning IP Addresses

Each Switch must be assigned its own IP Address, which is used for communication with an SNMP network
manager or other TCP/IP application (for example BOOTP, TFTP). The Switch's default IP address is
10.90.90.90. You can change the default Switch IP address to meet the specification of your networking
address scheme.
The Switch is also assigned a unique MAC address by the factory. This MAC address cannot be changed,
and can be found by entering the command
DGS-1210-28P/ME:5# create account admin newmanager
Command: show switch
Device Type
MAC Address
IP Address
VLAN Name
Subnet Mask
Default Gateway
System Boot Version
System Protocol Version
System Firmware Version
System Hardware Version
System Serial Number
System Name
System Location
System up time
System Contact
System Time
STP
GVRP
IGMP Snooping
VLAN Trunk
802.1X Status
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a ALL
The Switch's MAC address can also be found from the Web management program on the System
Information window in the Configuration folder.
The IP address for the Switch must be set before it can be managed with the Web-based manager. The
show switch into the command line interface, as shown below.
: DGS-1210-28P/ME
: 9C-D6-43-60-4F-A4
: 10.90.90.90 (Manual)
: default
: 255.0.0.0
: 0.0.0.0
: 1.00.013
: 2.001.004
: 6.10.B020
: A1
: S3221DB000014
: 2
:
: 0 days, 1 hrs, 8 min, 4 secs
:
: 01/01/2014 01:07:31
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
Figure 3.6 Show switch command
1 1 9 9