Advertisement

Quick Links

Operating Instructions for Porsche Baby Seat ISOFIX
33

Advertisement

Table of Contents
loading

Summary of Contents for Porsche ISOFIX

  • Page 1 Operating Instructions for Porsche Baby Seat ISOFIX...
  • Page 2 Deviations from the described product contents Version: December 2008 any type is only permissible with the written are possible in various countries due to country- Printed in Germany authorisation of Dr. Ing. h.c. F. Porsche AG. specific regulations and statutory requirements.
  • Page 3 Dear Customer, We thank you for the trust you have shown in buying this product and congratulate you on your new Porsche Baby Seat ISOFIX. The Porsche Baby Seat ISOFIX was developed in collaboration with BRITAX Römer Kindersicherheit GmbH and has been tested and released for your Porsche.
  • Page 4: Table Of Contents

    Adjusting the Headrest ......... 42 Buckling in your Baby ........43 Securing your Child properly ......45 Fastening the Baby Shell with ISOFIX Adapter and Support Leg ....45 Properly Securing the Baby Shell with ISOFIX Adapter ........49 Removing the Baby Shell with ISOFIX Adapter and Support Leg ....
  • Page 5: Safety Notes

    Make sure that the head of your child can not f The Porsche Baby Seat ISOFIX must not be come near the side airbag when the child leans used in the rear seat area of the 911.
  • Page 6: Notes

    In order to protect your baby, do not place any Danger! f An accident with an impact speed of more than objects in the footwell in front of the ISOFIX 10 km/h (6 mph) can cause damage to the Danger of burns by hot plastic parts on the adapter.
  • Page 7: Operation

    Use in the Vehicle B) with ISOFIX fastening system and support leg D D d The Porsche Baby Seat ISOFIX is approved for two (semi universal) different types of installation: The ISOFIX adapter is fastened with a semi- Child seat Testing and approval universal approval.
  • Page 8: Removing The Support Cushion

    2. With the buttons pressed, swivel the carrying handle forward or back until the carrying handle engages in the desired position. Removing the Support Cushion Adjusting the Carrying Handle The support cushion improves the You can engage the carrying handle in three ergonomic properties for your baby.
  • Page 9 D D d Position A Position B Position C Carrying and transport in the vehicle Laying down and buckling in your baby Secure stand outside the vehicle Note You can swivel the carrying handle from position B to position A without pressing the buttons (3). Operation...
  • Page 10: Adapting The Headrest

    Adapting the Headrest Adjusting the Headrest 3. Push the headrest adjuster to the correct belt height and engage the headrest adjuster. A properly adapted headrest provides ideal 1. Open the buckle. support for your baby in the baby shell. 2. Tilt the headrest adjuster out of the lock.
  • Page 11: Buckling In Your Baby

    Warning! Twisted or interchanged shoulder belts can D D d severely injure your child. f Do not twist or interchange the shoulder belts. 4. Guide the shoulder belts over your baby’s shoulders. Buckling in your Baby 2. Open the buckle (press the red button).
  • Page 12 Danger! Danger of severe or mortal injuries if your child is buckled in improperly. f Make sure that the belt tongues are properly engaged in the buckle. f Make sure that the shoulder belts fit snugly. f Make sure that the shoulder belts are not too tight against the neck.
  • Page 13: Securing Your Child Properly

    1. Clip the two insertion aids (12), with the f The lap belts opening facing up, onto the two ISOFIX – the shoulder belts of the baby shell are snug (10) must pass as low as fastening points (13).
  • Page 14 (20) against each other. Danger of injury when swivelling the damping bar back. f Always hold the damping bar when carrying the ISOFIX adapter. 2. Swivel the damping bar (14) of the ISOFIX adapter (15) upward. Operation...
  • Page 15 D D d 6. Pull on the ISOFIX adapter (15) to check 7. Press the adjusting button and pull the Danger! (17) whether it is engaged on both sides. support leg out until the support leg rests securely on the vehicle floor.
  • Page 16 8. Make sure that the top side of the ISOFIX Notes Danger! (15) adapter is free of foreign objects. Never allow the support leg (17) to dangle in the Danger of severe or mortal injuries if the 9. Make sure that the carrying handle is in the air and never place objects under it.
  • Page 17: Properly Securing The Baby Shell With Isofix Adapter

    In all vehicles, it is impermissible to use the the seat surface, child seat on the front passenger seat without f the baby shell is fully engaged on the ISOFIX deactivating the passenger airbag. adapter and the green marking on the release...
  • Page 18: Fastening The Baby Shell With The Three-Point Seat Belt

    (18) against damage. (baby faces to the rear). 4. Remove the ISOFIX adapter from the vehicle. 2. Make sure that the carrying handle is in position A (refer to section “Adjusting the Carrying Handle”). 3. Pull the vehicle’s three-point seat belt out and guide it over the baby shell.
  • Page 19 D D d 5. Lay the lap belt (35) into the light blue belt 6. Tighten the lap belt by pulling on the diagonal Danger! (36) belt (37). guides on both sides of the baby shell edge. Child seats can cause severe or mortal 7.
  • Page 20: Properly Securing The Baby Shell With The Three-Point Seat Belt

    Properly Securing the Baby Shell Danger! with the Three-Point Seat Belt Passenger airbags can cause severe or mortal injuries to children when they are In the interests of your baby’s safety, check that triggered. f the baby shell is fastened facing opposite the f In all vehicles, it is impermissible to use the direction of travel, child seat on the front passenger seat without...
  • Page 21: Removing The Baby Shell With The Three-Point Seat Belt

    D D d Removing the Baby Shell with the 2. Open the buckle (34) and take the lap belt (35) out of the light blue belt guides (36). Three-Point Seat Belt 3. Return the three-point seat belt to its original (38) 1.
  • Page 22: Fitting The Sun Shade

    Fitting the Sun Shade 3. Pull the elastic seam over the upper edge of 4. Guide the rubber loops (23) of the sun shade the baby shell. trough the rubber loops of the seat shell cover (26) and engage the rubber loops of the sun 1.
  • Page 23 D D d 5. Tighten the sun shade by pulling the edge of (24) the hood over the carrying handle moving the handle to position A. Operation...
  • Page 24: Care Instructions

    Cleaning Caution! Risk of damage due to improper cleaning. f Please observe the instructions on the cover’s laundry label. If the cover is washed at a temperature higher than 30°C (86°F), the cover fabric may bleed. f Do not spin-dry the cover and never dry it in an electric dryer (the fabric could separate from the cushion).
  • Page 25 6. Open the snap fasteners (39) on the left and 9. Disengage the rubber loops (26) of the seat 11.Thread the buckle out of the seat shell (22) right sides of the seat shell cover. shell cover from the hooks below the cover.
  • Page 26: Fitting The Cover

    Fitting the Cover Warning! Twisted or interchanged shoulder belts can severely injure your child. f Do not twist or interchange the shoulder belts. 1. Fit the cover in the reverse order. 12.Pull the seat shell cover upward slightly and Removing the Belts pull the seat shell cover off over the headrest.
  • Page 27 3. Pull the shoulder belts out of the belt slots 4. Pull out the Triglide (32) with which the 5. Push the belt loops back on the short side of (28) and the shoulder pads (31). (32) shoulder belt is fastened at the bottom of the Triglide and disengage the belt loops.
  • Page 28: Installing The Belts

    Installing the Belts 3. Engage the Triglide (32) in the long belt loop 4. Pull on the belt until the Triglide (32) lies (engage the long side of the Triglide first, then straight in the opening of the seat shell. the short side).
  • Page 29 7. Engage the shoulder belts in the Warning! (25) connecting piece again. Twisted or interchanged shoulder belts can 8. Fit the cover (refer to section “Fitting the severely injure your child. Cover”). f Do not twist or interchange the shoulder belts. 6.
  • Page 30: Buckle Care

    Buckle Care Proper functioning of the buckle makes an important contribution to safety. Malfunctions of the buckle are mostly due to contamination. Malfunction: – The belt tongues are ejected slowly when the red button is pressed. – The belt tongues no longer lock into place and are ejected again.
  • Page 31 Malfunction: – The belt tongues can no longer be inserted into the buckle (8). Remedy: – Press the red button to release the buckle (8). Care Instructions...
  • Page 32: Notes On Disposal

    Notes on Disposal Please observe the disposal regulations valid for your country. Disposal of the packaging Collection container for cardboard Disposal of individual parts Cover Residual waste, incineration Disposal in the appropriate Plastic parts containers according to the identification Metal parts Collection container for metals Collection container for Belt strap...

Table of Contents