Toshiba AW-DC1000CM Owner's Manual page 28

Use "TUB CLEAN" button to select either "TUB WASH" or "TUB DRY" . Since the two modes are different,
please make sure to confirm through the displaying of indicator.
"TUB WASH" course
The dirt from clothes or waste water on the wash/
spin basket will cause the smell or the problem
of water draining. Such dirt from the washing
process will then make the laundry dirty. If you are
in such case, please use "TUB WASH" program
once a month. Or in case the clothes have been
starched, please use the "TUB WASH" program to
remove the dirt of the starch from the basket.
"TUB WASH" Process
Water intake/Stir ( 1)
Soak
Wash
Drain/Spin ( 2)
Water intake/Stir ( 1)
Rinse
Drain/Spin ( 2)
1 The pulsator stir while the water level
increases gradually. For the tub water, the
operation may slightly differ.
2 The water spins while draining out.
•
Do not use "TUB WASH" program continuously.
When you want to dry the wash tub/spin basket.
•
Run "TUB DRY" after washing is finished, to prevent mildew
by removing the moisture of the tank. Please run the course
once a week.
Please do not add clothes during the course.
Tips
•
Mildew of Washing-Spinning tank occurs depending on the environment.
•
Once mildew occurs, it can not be removed by "TUB DRY" process. Therefore, it is recommended to run "TUB DRY" and
"TUB WASH" regularly.
28
MAINTENANCE
Cleaning the tub
•
Normally use soap powder.
•
The amount of detergent must be more than the guided
Standard Detergent Amount.
1
Turn the POWER on.
about 11 min
2
Press the
about 20 min
3
Press the
about 3 min
•
about 3 min
4
about 11 min
When the pulsator (spinning board) starts to stir, add the
chlorine-type whitening detergent about 300 ml. (300 g) to
the basket.
about 3 min
•
•
about 3 min
5
Close the lid.
•
Finish "TUB WASH" process.
•
"TUB DRY" course
1
2
•
button and select TUB WASH.
button.
Other indicator will light off.
light up only "TUB WASH" indicator.
Add it at the first used water.
Do not put any clothes in the basket during the "TUB WASH"
program.
If the lid is opened during the operation, the operation will
stop before the draining and rinsing process.
Beeping when the operation is finished.
Power on, and press the
select "TUB DRY" .
Close the cover and press the
High-speed revolving for about 30 minutes can dry the
washing-spinning tub through air intaking and revolving
the pulsator.
Clean the tub.
button twice, then
button.