M1505
V04
1 - Add RTV to C6 and R41.
2 - R29, R31, R42, R43, R44 and R45 are used to
level up their respective pots during wave soldering.
3. Please break the panel before testing
4 - Break the connection of XLR J4 as per diagram.
5 - Do not forget to add a 2-pin header
to the thermistor harness assembly
as shown below:
INSERT
THERMISTOR HARNESS
PHOTO HERE
SEE LAYOUT DIAGRAM
PRODUCTION NOTES
MAINS VOLTAGE INPUT SETTING (NA<->CE)
Remove this
piece.
Break this
connection here.
SET JUMPER P200 TO "115V" FOR NA.
SET IT TO "230V" FOR CE.
INSERT
ICE MODULE
PHOTO HERE.