Myq ® Light Controls; Programming To A Myq ® Light Control - Chamberlain 374UT Instructions Manual

MyQ LighT COnTROLS
®
Programming to a MyQ
The images throughout this manual are for reference only and your product may look different.
1
Plug the lamp into the module and plug the module
into an electrical outlet (the LED on the module will
flash). NOTE: Make sure the lamp is switched ON.
3
Press and release the LEARN button on the module (the
LED on the module will light).
5
The lamp's light bulb will blink and the LED on the
module will turn OFF when the device has been
programmed.
Light Control
®
2
If the lamp is not ON, press and release the Power button
on the module to turn the lamp ON.
4
Press the button on the remote control.
14
LED
Button