GE PFH28 Owner's Manual & Installation Instructions page 34

Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)
(Models PYE, CYE, GYE, DYE, PWE, CWE, and ZWE only)
WARNING
doors open. These models must be secured with the
anti-tip floor bracket to prevent tipping forward, which
could result in death or serious injury. Read and
follow the entire installation instructions for installing
the anti-tip floor bracket packed with your refrigerator.
NOTE:
GEAppliances.com.
MATERIALS YOU MAY NEED
MEASURE CABINET
AT-1
OPENING AVAILABLE VS.
REFRIGERATOR WIDTH
Measure width of cabinet opening where
refrigerator will be placed, W.
Be sure to account for any countertop overhang,
baseboard thickness and any clearance desired.
refrigerator will be placed approximately in the
middle of this opening.
Rear Wall
W
34
Tip Over Hazard.
Anchor Sleeves
Baseboard
Thickness or
Countertop
Overhang
Clearance
RH Side
Anti-Tip Floor Bracket Installation
TOOLS YOU WILL NEED
Pencil
LOCATING THE ANTI-TIP
AT-2
FLOOR BRACKET
A
Place the anti-tip floor bracket locator template
up against the rear wall, within W, and in line
with the desired location of the RH side of the
B Place the anti-tip floor bracket onto the locator
template with its RH floor holes lined up with
the floor holes indicated on the template sheet,
or the RH side of the refrigerator.
C Hold down in position and use the anti-tip floor
bracket as a template for marking the holes
based upon your configuration and type of
construction as shown in Step 3. Mark the hole
locations with a pencil, nail or awl.
NOTE:
all the acceptable mounting configurations for
floor bracket for your configuration.
Tape measure
2 Wall Holes
RH Holes
Rear RH
Corner of
Cabinet Wall
RH Side of
Refrigerator
Template Sheet
49-60748-3