Changing The Remaining Ink Level Notification Setting - Canon g3000 series Online Manual

Changing the remaining ink level notification setting

You can switch the remaining ink level notification setting and reset the remaining ink level count.
This section describes the procedure for changing the remaining ink level notification setting.
Remaining Ink Notification Settings
You can switch the remaining ink level notification setting.
1. From the Canon IJ Printer Utility
2. Check that the printer is on, and click Remaining Ink Notification Settings.
The dialog appears.
3. Set the remaining ink level notification.
Select Enable to display an error message when the remaining ink level runs low.
Select Disable to prevent the error message from being displayed.
Important
• Before enabling Remaining Ink Notification Settings,
and reset the remaining ink level count by running Resets the Remaining Ink Level Count.
However, if you reset the count by operating the operation panel of the printer, the setting in the
printer driver is unnecessary.
• If you disable Remaining Ink Notification Settings, you must visually check the remaining ink
level. Replenish the ink before the ink level falls below the lower limit line.
4. Apply the setting.
Click OK.
When the confirmation message appears, click OK.
From this point on, the setting is applied.
Resets the Remaining Ink Level Count
You can reset the remaining ink level notification counter.
1. From the Canon IJ Printer Utility
2. Check that the printer is on, and then click Resets the Remaining Ink Level Count.
The dialog appears.
3. Apply the setting.
pop-up menu, select Remaining ink level setting.
replenish
pop-up menu, select Remaining ink level setting.
194
all inks to the upper limit line