Inlet Hose Connection - Daewoo DWD-FD1411 Instruction Manual

INLET HOSE CONNECTION

The machine should be connected to the water mains using the the new hose sets supplied.
NEVER reuse old hoses.
If using only one water tap or if there is only one water inlet valve, connect the inlet hose to the
cold water inlet valve.
Caution: Be careful not to confuse hot water inlet and cold water inlet.
For Ordinary Tap
1 Pull down the collar of the
inlet hose to separate it
from the water tap
adapter.
4 Remove the tape, and
screw tightly connector B
into connector A.
For Screw-Shaped Tap
1 Connect the inlet hose to
the water tap by screwing
the connector tightly.
Connector
Hose
Downloaded From WashingMachine-Manual.com Manuals
2 Loosen the four screws
properly in order to fit into
water tap.
5 Connect the inlet hose to
the water tap adapter by
pulling down the collar of
the hose end.
Raccorclement A
Raccorclement B
2 Connect the connector-
inlet supplied if
necessary.
Rubber
Packing
Connector
Connector
inlet
Rubber
Connector
Packing
Hose
Connector
5
3 Fit the water tap adapter
into the water tap and
tighten the four screws
evenly while pushing up
the adapter so that the
rubber packing can stick
to the water tap tightly.
TAPE
6 Connect the inlet hose
adapter of the hose to the
water inlet of the washer
by turning it clockwise
until it is tight.
• Please check the rubber
packing is present inside the
inlet hose adapter of the hose.
3Connect the inlet hose
adapter to the water inlet
of the machine and turn it
until tight.
*Check the packing in the inlet