Table of Contents
Advertisement
4.
Install the SIMM into the slot at an angle,
and then push it gently toward the vertical
until it clicks into place.
5.
Re-install the access cover and secure the access cover with the two
screws.
6.
Close the rear cover.
7.
Reconnect the interface cable (printer cable) to your computer. Plug
the power cord into the AC outlet, and then turn on the power switch.
✏ Note
To check that you installed the SIMM correctly, print the configuration
sheet by using the selection in the driver and check it to make sure it
shows the additional memory. See
Chapter 3.
"Print Configuration and Fonts"
4-5
CHAPTER 4 OPTIONS
in
Advertisement
Table of Contents
