Radio; Setting The Clock And Alarm Times; Selecting The Alarm Mode; General - Philips AJ3120/79 User Manual

RADIO

You can use this set solely as a radio!
1 Adjust RADIO
2 Select your waveband by adjusting the BAND switch.
3 Adjust TUNING to tune to your desired station.
4 Turn the VOLUME control to adjust the volume level.
5 Adjust RADIO
To improve reception:
FM: extend and position the pigtail for optimum reception.
AM: uses a built-in aerial inside the set. Direct the aerial by adjusting the
position of your set.

SETTING THE CLOCK AND ALARM TIMES

The time is displayed using the 24-hour clock
IMPORTANT! To adjust the clock and alarm times accurately, always make sure
you press the HR or MIN buttons separately and not
simultaneously.
1 Turn the clock control to SET TIME or SET ALARM to set the clock or alarm
time respectively.
2 Press HR or MIN repeatedly or hold down on the respective button to adjust
the hours and minutes.
3 Release HR or MIN when you reach the correct setting.
4 After you have set both the hour and minutes, turn the clock control to
CLOCK to run on clock time.

SELECTING THE ALARM MODE

GENERAL

If you wish to use the alarm, you must first set the alarm time first. You can
choose from two different alarm modes to wake you up: by radio or buzzer.
• Select your choice of alarm mode by adjusting ALARM to RAD or BUZ.
to ON to switch on the radio.
•
OFF ON
to OFF to switch off the radio.
•
OFF ON