Table of Contents
Advertisement
INSTALLATION
POWER SUPPLY
1 Check if the power supply, as shown on the type plate located on
the bottom of the set, corresponds to your local power supply. If it
does not, consult your dealer or service center.
2 Connect the plug to the wall outlet.
3 To disconnect the set from the power supply completely,
remove the plug from the wall outlet.
CLOCK MEMORY BACKUP
The clock memory backup allows your alarm and clock time settings to be
stored for up to a day when there is a power interruption e.g. power fail-
ure. The complete clock radio and display illumination will be switched off.
As soon as the power supply returns, the display will indicate the correct
time.
1 Remove the battery door to insert a 9 volts 6F22 type battery (not
included) for backup.
2 Replace the battery door.
NOTE: If no backup battery is installed or the power interruption is
prolonged, you will need to set the clock and alarm times
again. Batteries contain chemical substances so they should
be disposed of properly.
Hide quick links:
Advertisement
Table of Contents
