How To Operate By Remote Control - McIntosh C100 Owner's Manual

How to Operate HR100
Mute
Press the MUTE push-button to mute audio in all LISTEN
outputs.
Mono
Press the MONO push-button to combine left and right ste-
reo signals to mono at all MAIN, AMPLIFIER, LISTEN
and HEADPHONES Outputs.
Audio
Press any of the eight Audio push-buttons to select a LIS-
TEN program source.
CD/Tape
Use these push-buttons to operate a CD player, CD changer
or tape recorder, when the component is connected to the
C100 with a McIntosh RCT Translator.
Numbered and +10 Push-buttons
Press push-buttons 0 through 9 to access tuner station pre-
sets, CD tracks or CD discs. When using a McIntosh
MCD7009 CD player, access track numbers higher than 10
by first pressing +10 and then a number push-button.
Disc and Track
Use the DISC and TRACK push-buttons when a CD player
or changer is being used.
Tuner Push-buttons
Use with a McIntosh tuner. Select AM or FM broadcast
band. Press and release SEEK Up or Down to move from
station to station. Press and hold a SEEK push-button to
move continuously from station to station. Press REVIEW
to start the automatic brief audition of each of the presets
stored in the tuner memory. Press REVIEW a second time
to stop on a station preset and exit the Review process.
Processors
Press the LISTEN PROCESSOR push-button to activate
rear panel processor connections to add signal processing
from an external processor to the LISTEN Outputs. Press
the RECORD PROCESSOR push-button to activate rear
panel connections to add signal processing from an external
processor to the RECORD outputs.
How to Operate the HR100
Record Monitor
Press the REC (Record) Monitor push-button to listen to the
signals being fed to the RECORD OUTPUTS.
Volume
Press the Up or Down VOLUME push-button to raise or
lower the listening volume level. The Record Outputs are
not affected.
Trim
Press TRIM to enter the Input Volume Level Trim mode.
Press a second time to exit the Trim mode.
Display
Press the DISPLAY push-button to cycle the Volume Dis-
play between dB and % of volume indications.
ACC ON - OFF
Press ACC ON or ACC OFF to turn power ON and OFF of
components that are connected with a McIntosh RCT
Translator - Repeater. Only the ACC ON push-button is
active with the McIntosh LV or DVD Disc Player.
NOTE: When other brands of components are connected with a
McIntosh RCT Translator, refer to the RCT Owner’s
Manual for further information on alternate HR100
push button functions.
17