Table of Contents
Advertisement
I cannot register my Motorola MBP2000PU to the
base station
• Try resetting the base station. You can do this by:
N
• Holding
on the base station for about 9 seconds until
the Talk/Message LED blinks.
N
• Release
and press it again immediately.
• The Talk/Message LED light should light up once more.
• Register your Motorola MBP2000PU to the base station.
See page 32 on how to register your Motorola
MBP2000PU to he base station.
My email could not be delivered due to connection
to the server on port 25 timed out
• You may need to change the port setting on an outgoing
mail server for one of your email accounts.
I cannot access Internet radio broadcast
• Your Motorola MBP2000PU must join a Wi-Fi network
that is connected to the Internet.
• For information about joining a Wi-Fi network, see
page 49.
Interference
• Noise interference on your radio or television
92
• Your base may be too close. Move it as far away as
possible.
There is no dial tone
• Your Motorola MBP2000PU may not be registered to a
base station.
There is no ring tone
• The ring tone is deactivated, see page 31.
• Increase the volume.
Caller ID does not work
• Check your subscription with your network operator.
• If you subscribe to high-speed Internet service (Digital
Subscriber Line - DSL) through your telephone lines, you
must install a DSL filter between the base and the
telephone wall jack. The filter will prevent noise and
caller ID problems caused by DSL interference. Please
contact your DSL service provider for more information
about DSL filters.
A new contact cannot be stored
• The contacts list is full. Delete an entry to free memory.
Help
Advertisement
Table of Contents
