Compaq P1100 Service Manual page 12

Maximum Refresh Rates
This monitor is capable of the maximum refresh rates listed in the
following table. However, the video adapter installed in your
computer must also be capable of supporting these refresh rates in
order for them to operate. Most of the new video adapters being
shipped and sold in computers today are capable of supporting these
calculated refresh rates. Certain video adapters may provide different
timing parameters which could result in slightly different maximum
refresh rates.
Maximum Refresh Resolutions
640 × 480 at 160 Hz
800 × 600 at 160 Hz
1024 × 768 at 140 Hz
1280 × 1024 at 110 Hz
1600 × 1200 at 95 Hz
User Modes
The video controller signal may occasionally call for a mode that is
not preset if:
You are not using a Compaq standard graphics adapter.
You are not using a preset mode.
If this occurs, you may need to readjust the parameters of the
monitor screen by using the on-screen display. User changes can be
made to any or all of these modes and saved in memory. The
monitor automatically stores the new setting, then recognizes the
new mode just as it does a preset mode. In addition to the 18 factory
preset modes, there are fifteen user modes that can be entered and
stored.
Energy Saver Feature
The energy saver feature has three different modes of operation:
By selecting settings in the computer's Energy Saver utility, you are
able to determine the length of the inactivity period before the
monitor goes into sleep mode.
The following table describes the monitor energy saver levels
available during the different modes of operation.
Mode
Full Power
Standby/Suspend
Sleep
Off
Refer to your computer manual for instructions on setting energy
saver features (sometimes referred to as power management
features).
English 1-13
1-14
Full Power
Standby/Suspend
Sleep
Energy Saver Levels*
Power Usage Description
Less than 145 Watts ON = Normal operation
Power LED is green.
Less than 15 Watts Monitor screen is blank. LED blinks amber
and green. There is a brief warm-up
period before returning to full power mode.
Approximately 1 Watt Monitor screen is blank. LED turns amber.
There is a brief warm-up period before
returning to full power mode.
0 Watts Monitor screen is blank. LED is OFF. There
is a brief warm-up period before returning
to full power mode.
The energy saver features for monitors only work when
connected to computers that have energy saver features.
English