Installation Notes - Honda CB Hornet 2016 Owner's Manual

2. Remove the rear axle nut.
3. Remove the drive chain (1) from the
driven sprocket by pushing the rear
wheel forward.
4. Remove the
side collar and rear wheel from the
swingarm.
(2)
(1) Drive chain ¼Mª k bo pS u ½
(2) Rear axle shaft ¼fj;j ,Dly "kkW ¶ V½
64
rear axle shaft

Installation Notes:

To install the rear wheel, reverse the
removal procedure.
Make sure that the slot on the swingarm is
(2),
located in the lug in the brake caliper.
Tighten the rear axle nut to be specified
torque:
Rear axle nut torque:
88 N·m (8.9 kgf·m , 65 lbf·ft)
When installing the wheel carefully fit the
brake disc (for CBS) between the brake
pads to avoid damaging the pads. Adjust
the brake (for STD).
After installing the wheel, apply the brake
(1)
several times and then check if the wheel
rotates freely. Recheck the wheel if the brake
drags or if the wheel does not rotate freely.
If a torque wrench was not used for
installation, see your Honda dealer as
soon as possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
Honda Motorcycle & Scooter India Pvt. Ltd.