Advertisement
OPERATION
1. RCA Input Jacks
4. Low Pass Frequency
7. Remote Control Jack
CONTROL AN D CROSSOVER
1. RCA Input Jacks- Low level high impedance inputs. Use high quality RCA cables
designed for mobile applications.
2. Input Level Control - adjust the input level for marked channels. Turn clockwise to
increase the level, counterclockwise to decrease. Amplifiers will run cooler and
produce less system noise at lower level settings.
3. Subsonic Filter Frequency - adjust counterclockwise to set to a lower frequency.
Only rumbles should be eliminated
4. Low pass frequency- adjusting clockwise: crossover lets through higher
frequencies - see scale
5. Bass Boost - adjust the sub boost level of the selected frequency output
0dB - +12dB
6. Phase control- adjust the relative phase of the output between 0-180 degrees for
faster bass, that does not „hunt" the front speakers.
7.
Remote control jack - for connecting the remote control (provided)
8. Master/Slave Switch - Choose if the amplif ier should operate as master or slave.
(Remote control only of the master amplif ier). The slave-mode bypasses all
switches, as this is regulated by the master amplifier.
9. Slave input jack -Used to connect 2 amplifiers (bridging). The slave mode bypasses
normal input jacks and controls.
2. Input Level Control
5. Bass Boost Control
8. Master/Slave Switch
13
3. Subsonic Filter
6. Phase Control
9. Slave Input Jack
Advertisement
