Exterior Moisture Control - Whirlpool 3XRA700-JWARG480PW01 Repair Manual

English
ADJUSTING THE TEMPERATURES
I
I
I
I
For the correct operation we suggest you adjust the tempera-
ture control knobs as indicated in figure.
The left control knob adjusts the temperature in the freezer
compartment: the right control knob adjusts the temperature in
the refrigerator compartment.
To obtain colder temperatures in the refrigerator compartment
turn the relevant control knob to the higher numbers and the
freezer control knob to position A; to obtain warmer temperatu-
res turn the refrigerator control knob to the lower numbers and
the freezer control knob to position B.
To obtain colder temperatures in the freezer compartment turn
the freezer control knob to position C and the refriqerator con-
trol knob to position 3.
EXTERIOR MOISTURE CONTROL
EXTERIOR MOISTURE CONTROL
In normal ambient conditions, set the switch to position "OFF".
In particularly high humidity ambient conditions, we suggest
you set the switch to the position "ON". In this condition, the
energy consumption is slightly higher than the declared value.
USE OF THE REFRIGERATOR
COMPARTMENT
(Fig. 6)
We recommend that you wrap all items stored in the refrigerator
compartment in cling films, aluminium foil or keep them in a
covered container. This prevents foods from losing their fresh-
ness and stop strong smells and flavours being transferred
from one foods to another. Some fruits with particularly thick
rind or skin, can be stored without wrapping.
Different foods are best stored in the positions indicated below
(Fig. 6):
Meat, fish and delicate foods: store in the appropriate com-
partment where the temperature is some degrees lower than
the rest of the refrigerator. They can then be stored for extra
days in the refrigerator without having to freeze them.
The correct storage of these foods depends however on their
original freshness, the packing, the room temperature and on
the temperature adjustments (see previous paragraph).
Eggs, cheese, dairy produces: use the appropriate com-
partment in the inner door liner.
Butter: store in the compartment in the inner door liner.
Fruit and vegetables: store in the crisper drawer.
Beverages: store on the inner door liner racks or in the
bottles rack.
Canned foods: once the can has been opened, transfer un-
used food into a non-metallic container.
Important: Store all foods so as to permit free circulation of air.
Allow cooked food to cool before storing in the
refrigeratOr
compartment. Store liquids in covered containers.
Adjusting the refrigerator shelves
Shelves can be adjusted to match the way you use your refrige-
rator. Glass shelves are strong enough to hold bottles, milk and
other heavy food items. However we suggest you remove
them carefully.
To remove the shelves (Fig. 7-A)
1. Lift up at front.
2. Slide the shelf out with an even, constant pull to the stop.
3. Lift front and slide the rest of the way out.
To remove the bottles rack (Fig. 7-B)
1. Lift front of bottles rack.
2. Pull rack off the rear support.
To remove the snack bin (Fig. 7-C)
1. Slide the snack bin with an even, constant motion straight out
to the stop.
2. Lift the front.
3. Slide the bin the rest of the way out.
To move the shelf guides
1. Remove the shelf.
2. Lift the front of the guide. Pull guide off the rear support.
Repeat for the other guide.
To remove the crisper (Fig. 7-D)
The glass cover will fit only above full width crisper. Crisper
must be removed before removing cover.
1. Slide the crisper straight out to the stop.
2. Lift the front.
3. Slide the rest of the way out.
To remove the cover
1. Lift front of cover off supports.
2. Lift out cover by pulling up and out.
To replace the cover
1. Fit back of cover in notch supports on walls of refrigerator.
2. Lower into place.
Adjusting the crisper humidity control
(Figure 7-F)
You can control the amount of humidity in the crisper.
1. The control can be adjusted to any setting between LOW and
HIGH.
2. LOW lets moist air out of crisper for best storage of fruits and
vegetables with skins.
3. HIGH keeps moist air in the crisper for best storage of fresh
leafy vegetables.
Adjusting the meat drawer temperature (Figure 7-G)
The cold air flows against the meat drawer through an opening
between the freezer and the refrigerator. This helps to keep the
meat drawer colder than the rest of the refrigerator.
Slide the control to let more or less cold air through.
To remove the meat drawer (Fig. 7-E)
1. Slide the meat drawer out to the stop.
2. Lift the front.
3. Slide the drawer the rest of the way out.
To remove the cover
1. Remove the meat drawer and crispers.
2. Lift front of cover off supports.
3. Lift out cover by pulling up and out.
NOTE: Large bins are designed to fit in top portion of the refri-
gerator door only.
To remove the door bins, lift up and pull straight out (Fig. 8)
11