Step 2: Setting The Time - Sony LBT-V3900 Operating Instructions Manual

Step 1: Hooking up the system
(continued)
Using the remote
You can use the shaded buttons shown below
to operate Sony TV.
TV/VIDEO
To
Turn the TV on or
off
Switch the TV's
video input
Change the TV
channels
Adjust the volume
of the TV speaker(s)
Tips
• With normal use, the batteries should last for
about six months. When the remote no longer
operates the system, replace both batteries with
new ones.
• When you set the time, the demonstration is
deactivated.
To activate the demonstration again, press
DISPLAY/DEMO while the system is off.
Note
If you do not use the remote for a long period of
time, remove the batteries to avoid possible damage
from battery leakage.
When carrying this system
Do the following to protect the CD
mechanism.
1 Press FUNCTION repeatedly until "CD"
appears in the display.
2 Hold down PLAY MODE and press 1/u to
turn off the system.
6
TV POWER
TV VOL +/–
TV CH +/–
Press on the remote
TV POWER.
TV/VIDEO.
TV CH +/–.
TV VOL +/–.
Step 2: Setting the
time
You must set the time before using the timer
functions.
1
1
Press t/CLOCK SET.
The hour indication flashes.
2
Press TUNING +/– to set the hour.
The clock uses the 12-hour system.
3
Press ENTER/NEXT.
The minutes indication flashes.
4
Press TUNING +/– to set the
minutes.
5
Press ENTER/NEXT.
The clock starts.
Tips
• If you make a mistake, start over from step 1.
• To change the time while the power is on, do the
following:
1 Press t/CLOCK SET.
2 Press TUNING +/– to select "SET CLOCK."
3 Press ENTER/NEXT.
4 Perform steps 2 through 5 above.
3,5 2,4