Lights And Bulbs; Xenon Headlights - BMW X5 M Owner's Manual

Mobility
4. Slide wiper blade out of the wiper arm.
5. Insert the new wiper blade and press it on
until it you hear it snap into the holder.
6. Fold down the wipers.
BMW X5 M: replacing the rear wiper
blade
1. Fold up the wiper arm.
2. Turn the wiper blade all the way back.
3. Continue turning the wiper blade all the
way so that it pops out of the holder.
4. Press the new wiper blade into the holder
until you hear it snap into place.
5. Fold the wipers in.
Lamp and bulb replacement
General information
Lights and bulbs make an essential contribu‐
tion to vehicle safety.
The manufacturer of the vehicle recommends
that you entrust corresponding procedures to
the service center if you are unfamiliar those or
if they have not been described here.
214
Replacing components
Online Edition for Part no. 01 40 2 956 993 - X/14
You can obtain a selection of replacement
bulbs at the service center.
Hints

Lights and bulbs

Danger of burns
Only change bulbs when they are cool;
otherwise, there is a danger of getting
burned.◀
Working on the lighting system
When working on the lighting system,
you should always reel off the lights affected to
prevent short circuits.
To avoid possible injury or equipment damage
when replacing bulbs, observe any instructions
provided by the bulb manufacturer.◀
Do not touch the bulbs
Do not touch the glass of new bulbs with
your bare hands, as even minute amounts of
contamination will burn into the bulb's surface
and reduce its service life.
Use a clean tissue, cloth or something similar,
or hold the bulb by its base.◀

Xenon headlights

Do not perform work/bulb replacement
on xenon headlights
Have any work on the xenon lighting system,
including bulb replacement, performed only by
a service center. Due to the high voltage
present in the system, there is a danger of fatal
injuries if work is carried out improperly.◀
Light-emitting diodes (LEDs)
Some items of equipment use light-emitting
diodes installed behind a cover as a light
source.
These light-emitting diodes, which are related
to conventional lasers, are officially designated
as Class 1 light-emitting diodes.