Suzuki Alto800 Manual page 56

BEFORE DRIVING
With tachometer
EXAMPLE
53M-04-099
WARNING
If you attempt to adjust the display
while driving, you could lose control
of the vehicle.
Do not attempt to adjust the display
while driving.
Clock (1) (if equipped)
The clock is shown when the ignition
switch is in the "ON" position.
To set the clock, follow the instructions
below.
• Hold in the indication selector and meter
illumination control knob (3) for more
than 2 seconds. Push the indication
selector and meter illumination control
knob (3) to advance the minute display
while the minute display is flashing.
Release the indication selector and
meter illumination control knob (3) for 5
seconds to set the minute display.
• The hour display flash after the minute
display is set. Push the indication selec-
2-37
tor and meter illumination control knob
(3) to advance the hour display. Release
the indication selector and meter illumi-
nation control knob (3) for 5 seconds to
set the hour display.
Odometer/Trip meter (2)
The odometer/trip meter is shown when
the ignition switch is in the "ON" position.
The odometer records the total distance
the vehicle has been driven. The trip meter
can be used to measure the distance trav-
eled on short trips or between fuel stops.
NOTICE
Keep track of your odometer reading
and check the maintenance sched-
ule regularly for required services.
Increased wear or damage to certain
parts can result from failure to per-
form required services at the proper
mileage intervals.
EXAMPLE
53M-04-100
When the ignition switch is turned to "ON"
with the lighting switch is in the "OFF" posi-
tion, the display shows three types of indi-
cation; odometer (A), trip meter A (B), trip
meter B (C) and clock (D). Push the
"MODE" knob (3) quickly to switch the indi-
cation among the four.
EXAMPLE
53M-04-101
53MH0-74E