Alfa Romeo Giulia Quadrifoglio 2017 Owner's Manual page 30

Driver Memory Seat
The driver memory seat buttons can
store and recall three different driver's
seat positions as well as outside power
mirror positions. Storing and recalling is
possible with the ignition in the ON or
STOP positions and the driver's side
door closed, or for three minutes after
having opened the driver's side door.
The performed position memory is
confirmed by a beep. To set a memory
profile, first adjust your seat (and power
mirror position if desired) with the
various controls until you are in the
desired position. Then, push the
specific button you want to assign the
set position to for 1.5 seconds. When a
new seat position is memorized, the
previously memorized position on the
same button is automatically
overwritten. Recalling a memorized
position is also possible for
approximately three minutes after the
doors are opened and approximately
one minute after the engine is stopped.
To recall a memorized position, push
the relevant button briefly.
Warning!
Adjusting a seat while driving may be
dangerous. Moving a seat while driving
could result in loss of control which could
cause a collision and serious injury or
death.
28
Seats should be adjusted before
fastening the seat belts and while the
vehicle is parked. Serious injury or death
could result from a poorly adjusted seat
belt.
Do not ride with the seatback reclined
so that the shoulder belt is no longer
resting against your chest. In a collision you
could slide under the seat belt, which could
result in serious injury or death.
Heated Seats
With the engine in the ON position,
push the driver or passenger heated
seat button located on the
instrument panel.
Heated Seat Buttons
You can select three heating levels:
Minimum — one orange indicator
illuminated on the buttons
Average — two orange indicator
illuminated on the buttons
Maximum — three orange indicator
illuminated on the buttons
After selecting a heating level, heat will
be felt within a few minutes.
A quick push of the heated seat button
will select the heat levels in order of
lowest to highest. Or, holding the switch
down from either "off" or the minimum
level for 1–2 seconds will automatically
select the maximum heat level.
When the heated seat function is not
active, pushing and holding the desired
heated seat button for 1–2 seconds will
activate the "fast maximum heating"
function. The heater produces a
boosted heat level for the first few
minutes of operation. After this, the
heat automatically lowers to reach the
normal temperature level for the
"maximum" setting.
The "minimum" setting is automatically
deactivated once a certain period of
time has elapsed. This varies on a
case-by-case basis, in accordance with
the specific operating conditions.
To lower the heat level, each quick push
of the switch will decrease by one level
04066S0004EM
until it is off. Holding the switch down at
any of the three levels for 1-2 seconds
will deactivate the heated seat.
Note: To preserve the battery charge,
this function cannot be activated when
the engine is off.