Alfa Romeo Giulia Quadrifoglio 2017 Owner's Manual page 210

This function can only be activated
within two minutes of cycling the
ignition to STOP.
To activate this function, move the lever
upward for at least three seconds.
Multifunction Lever
Function Deactivation
The function is deactivated if:
More than two minutes passes
before cycling the ignition to the STOP
position after having raised the lever
and putting the wipers into service
position.
The ignition is cycled to the ON
position and the windshield wiper
control is used.
If, after using the function, the ignition is
set back to ON with the blades in a
position other than rest position (at the
base of the windshield), they will only
208
return to rest position following a
command given using the stalk (stalk
upwards, into unstable position) or
when a speed of 3 mph (5 km/h) is
exceeded.
Replacing The Windshield Wiper
Blades
Proceed as follows:
1. Raise the wiper arm, press tab of
the attachment spring and remove the
blade from the arm.
09046S0001EM
Wiper Release Tab
2. Fit the new blade, inserting the tab
in the dedicated housing in the arm and
checking that it is locked.
3. Lower the wiper arm onto the
windshield.
Note: Do not operate the windshield
wiper with the blades lifted from the
windshield.
Windshield Washer
The window washer nozzles are fixed. If
there is no jet of fluid, first check that
there is fluid in the reservoir (see
paragraph "Engine Compartment" in
this chapter).
Windshield Washers
1 — Washer Nozzles
Then, check that the nozzle holes are
not clogged; use a needle to unblock
09046S0002EM
them if necessary.
Exhaust System
Adequate maintenance of the engine
exhaust system represents the best
protection against leaks of carbon
monoxide into the passenger
compartment.
If an unusual noise from the exhaust or
the presence of smoke in the
passenger compartment is identified, or
if the underbody or rear section of the
vehicle have been damaged, have the
09046S0003EM