Quick Start Guide - Samson Stage 200 Owner's Manual

Quick Start Guide

Follow these basic procedures for setting up and using your Stage 200 Wireless System.
1. Connect the SR200 receiver power adaptor
to the rear panel DC input, and then to an
electrical outlet. Fully extend the antennas
vertically.
2. Connect the receiver's appropriate ¼" outputs
to the input of a mixer, stereo, karaoke
machine, or any other line level input.
3. With the transmitter powered off, rotate the
bottom section and slide down to expose the
battery compartment. install two fresh AA
batteries into the VH200 handheld transmitter.
4. Place the SR200 receiver where it will be used
(the general rule of thumb is to maintain "line
of sight" between the receiver and transmitters
so that the person(s) using the transmitter can
see the receiver). Turn on the power of the
SR200 receiver.
Stage 200: Dual Handheld Wireless System 11