Using Your New Tv; Getting Started; Step 1: Install The Tv - Sony WEGA KE-MV42A1 Operating Instructions Manual

Using Your New TV

Getting Started

Step 1:
Install the TV
Securing the AC plug
You must secure the AC plug to the TV's AC IN
jack.
1
Attach the AC plug holder (supplied) to the
AC power cord.
AC IN (power
supply input)
jack of the TV
AC power cord
(supplied)
2
Clip on the AC IN jack until you hear
clicking.
To unplug the AC power cord, pull down the
AC plug holder by pushing in both sides of the
holder, then pull out the plug.
Note
• When you disconnect the AC power cord,
disconnect it from the AC outlet first.
8
Preventing the TV from falling down
After antenna and other equipment connections
are completed, be sure to attach the supplied
clamp screws to the rear of the TV, and thread a
sturdy cord or chain through it and attach it to a
wall or pillar.
1
Remove one of the two screws on the rear
of the TV, then install the supplied clamp
screw in the screw hole.
Plug holder
(supplied)
2
Repeat step 1 to install the other clamp
screw.
3
Attach a sturdy cord or chain securely to
each clamp screw, and attach the cord or
chain to a wall or pillar.
Attached
screw
Clamp screw
(supplied)