D-Link DSL-2870b User Manual page 32

D-Link DSL-2870B Dual Band Wireless N750 Gigabit ADSL2+ Modem Router User Manual
IP over Ethernet
Select the IP over Ethernet option, to use IP over Ethernet as the WAN service
connection.
After select the IP over Ethernet option, the following information will be available for
configuration.
In this section we can configure the following parameters.
ATM Service: Select the appropriate ATM service option here.
Option an IP address automatically: Select this option to allow the WAN
connection to automatically obtain an IP address from the service provider.
Option 60 Vendor ID: Enter the Option 60 Vendor ID here.
Option 61 IAID: Enter the Option 61 IAID value here.
Option 61 DUID: Enter the Option 61 DUID value here.
Option 125: Select to enable or disable the Option 125 option here.
Use the following IP address: Select this option to manually enter the WAN
connection details for this connection type.
WAN IP address: Enter the WAN IP address used here.
WAN subnet mask: Enter the WAN Subnet Mask used here.
WAN gateway IP Address: Enter the WAN Gateway IP address used here.
NAT: Select to enable or disable the NAT option here.
Fullcone NAT: After enabling the NAT option, we can select to enable or disable
the use of a full-cone NAT option here.
Firewall: Select to enable or disable the firewall option here.
IGMP Multicast Proxy: Select to enable or disable the IGMP Multicast proxy option here.
Web User Interface Configuration Page 32