Table of Contents
Advertisement
INSTRUTION FOR USE
FEATURES
RESUME and HOLD
You can interrupt playback and continue (after a short
while at the stop position only) from the position
where playback has stopped (RESUME). You can also
lock all buttons of the set so that no action will be
executed (HOLD). Use the OFF – RESUME – HOLD
slider for these functions.
RESUME – continuing from where you have stopped
1 Switch the slider to RESUME during playback to activate RESUME.
y RESUME is shown.
2 Press 9.
3 Press 2; on the set or press 2; or RESUME on the
remote control to resume playback.
y RESUME is shown and playback continues from where
you have stopped.
• To deactivate RESUME, switch the slider to OFF.
y RESUME goes off.
TIP:
– Resume is also cancelled if you have opened the disc lid or disconnected
your player from the power supply.
HOLD - locking all buttons
• Switch the slider to HOLD to activate HOLD.
appears and all buttons are locked.
HOLD
When any key is pressed, HOLd is displayed.
• To deactivate HOLD, switch the slider to OFF.
disappears.
HOLD
ESP - Electronic Skip Protection
The ESP duration is 120 seconds for CD playback,
400 seconds for MP3 disc playback and
30 seconds for VCD playback.
The ELECTRONIC SKIP PROTECTION system prevents sound loss or unstable
playback caused by light vibrations and shocks. Continuous playback is thus
ensured. ESP does not prevent playback interruptions during vigorous
running. It does not protect the unit against any damage caused by
dropping!
Press ESP repeatedly during playback to toggle between ESP ON and ESP OFF.
• When
appears, ESP is activated.
• When
disappears, ESP is deactivated
1- 7
Programming track numbers
You can select up to 20 tracks and store them in the
memory in a desired sequence. You can store any
track more than once.
1
In the stop mode, press
on the remote control.
PROGRAM
stored tracks is displayed.
2
Select a track with
3
Press
PROGRAM
RESUME
control to store the track.
4
Select and store all desired tracks in this way.
Press 2; to start playback of the program
5
Playback starts.
RESUME
– P-FULL appears when the program memory is full.
HOLD
Clearing the program
You can clear the program by
• pressing 9 again in th stop mode;
• powering off the player;
• opening the disc lid;
• pressing and holding
• pressing PROG on the remote control during playback.
– P-CLEAr appears on the display of the player for VCD, CD and
MP3-CD.
M P3
ALBUM
– PROGRAM CANCEL appears on the TV screen for VCD.
FEATURES
on the set or
PROGRAM
appears and P with the number of
§
or §
.
on the set or
on the remote
PROG
TIP:
during playback
PROGRAM
TIP:
PROG
PROGRAM
Advertisement
Table of Contents
