Safety Information - Pioneer FH-P5000MP Service Manual

1

SAFETY INFORMATION

QQ
3 7 63 1515 0
CAUTION
A
This service manual is intended for qualified service technicians; it is not meant for the casual do-it-yourselfer.
Qualified technicians have the necessary test equipment and tools, and have been trained to properly and safely
repair complex products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability of the product and may void the
warranty. If you are not qualified to perform the repair of this product properly and safely, you should not risk
trying to do so and refer the repair to a qualified service technician.
WARNING
This product contains lead in solder and certain electrical parts contain chemicals which are known to the
state of California to cause cancer, birth defects or other reproductive harm.
Health & Safety Code Section 25249.6 - Proposition 65
B
- Service Precaution
1. You should conform to the regulations governing
the product (safety, radio and noise, and other
regulations), and should keep the safety during
servicing by following the safety instructions
described in this manual.
2. Before disassembling the unit, be sure to turn off
the power. Unplugging and plugging the connectors
C
during power-on mode may damage the ICs inside
the unit.
3. To protect the pickup unit from electrostatic discharge
during servicing, take an appropriate treatment
TE
(shorting-solder) by referring to "the DISASSEMBLY" L 13942296513
on page 78.
4. After replacing the pickup unit, be sure to check the
grating. (See page 74.)
5. When replacing the power IC or heat sink, apply
silicon grease (GEM1057). At this time, apply as thin
and uniformly as possible on the entire power IC
D surface. Do not let air get trapped between the power
IC and heat sink.
E
www
F
2
1
http://www.xiaoyu163.com
2
x ao
y
. i
FH-P5000MP/XM/UC
2
http://www.xiaoyu163.com
3
8
Q Q
3 6 7 1 3
u163
.
3
4
2 9 9 4 2 8
1 5 0 5 8 2 9 9 4
m
co
4
9 9
2 8 9 9