Alarms; Door Ajar Alarm; High Temperature Alarm; Instructions For Programming Ez Set Controls - Frigidaire FFH17F8HW0 Servicing

Alarms

Door Ajar Alarm

When the door is left open for five (5) minutes or more, the Door Ajar LED will light up and the control will beep
every five seconds. The alarm will be turned off when the door is closed or the "ALARM RESET" button is pressed.
The LED light will stay on until the door is closed. If the door is not shut after five (5) minutes, the alarm will sound
again. If after fifteen minutes the door is not shut, the interior light will turn off.

High Temperature Alarm

The High Temp LED will turn on and the control will beep every five (5) seconds if the temperature of the cabinet
remains above 23ºF for more than one hour. The alarm will be turned off when the "ALARM RESET" button is
pressed, but the High Temp LED will remain lit until the temperature is again below 23ºF.

Instructions for Programming EZ Set Controls:

Programming is determined by Model size.
Your Model size is shown on the serial plate inside the freezer as "Type 14F, 17F, 21F".
After plugging in the unit, wait for the display to flash the type Number "1".
1. For type U17F models, use this "1" and press the alarm reset key to lock it in.
2. For type U21F models, press the down key to display "0", then press the alarm reset key to lock it in.
3. For type U14F models, press the up key to display "2", then press the alarm reset key to lock it in.
To change the type programming procedure:
1. With unit unplugged, press and hold the up, down, and alarm reset keys while plugging in the unit.
2. The display will flash "1".
3. Release the keys and follow the programming instructions listed above.
Section 3 Electronic Control
3-3