Yamaha spx2000 Service Manual page 35

QQ
3 7 63 1515 0
TEST PROGRAM
Preparation
1) Cables
XLR (AES/EBU): 1 pc.
MIDI: 1 pc.
USB: 1 pc.
FC5 or OPEN JACK: 1 pc.
2) Measuring Instruments
Oscillator (output impedance: 150 Ω)
Oscilloscope (input impedance: 100 kΩ or more)
3) Personal Computer (PC): DOS/V machine
Using the USB cable, connect the USB connector of the main unit and the PC. Make settings
for the USB-MIDI driver on the PC.
For the USB driver, use a Windows 9x type one. (Use of the Windows 2000 or XP, USB
driver does not provide proper operation.)
4) Settings for USB-MIDI driver
In the "control panel" display on the PC, double click on "USB-MIDI Driver" to start up the
USB-MIDI driver and then make settings.
TE
L 13942296513
* Download the USB-MIDI driver from the YSISS Home Page.
(YSISS URL >>http://plaza.yamaha.co.jp/ysiss/exindex.nsf)
5) Program Version Check
If the main program is not the latest version, it must be upgraded to the latest program. For the methods to
www
check the program version and to write, refer to "Method for Writing the Program" on page 49.
.
http://www.xiaoyu163.com
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Q Q
3 6 7 1 3 1 5
(1) After starting the USB-MIDI driver
operation, click on "Thru ON/OFF".
(2) Clicking on this circle (1-1) will set
USB=MIDI to THRU.
If USB has become invalid by
SPX2000 USB initialization, press the
[OK] key to end the operation and start
up the USB-MIDI driver once again.
co
.
9 4 2 8
0 5 8 2 9 9 4 2 8
m
SPX2000
9 9
9 9
35