Adjustment Overview - Grizzly G0803 Owner's Manual

7.
Thread (2) M6-1 x 16 fence rail knobs into
table just enough so they will not fall out. Do
not tighten yet (see Figure 14).
Figure 14. M6-1 x 16 fence rail knobs installed.
8. Slide fence rail notches over knob threads
(see Figure 15), then tighten knobs to secure
fence rail snug against edge of table.
Notch Shaft
Fence Rail
Figure 15. Installing fence rail.
-16-
9. Insert "D" nut into slot shown in Figure 16.
10. Thread M6-1 x 24 fence rail knob up through
middle notch of fence rail, into "D" nut, and
tighten.
11. Pull fence lock lever up and place fence
assembly onto fence rail, making sure it
snaps into place, then push lock lever down
to secure fence (see Figure 16).
Figure 16. Fence installed on fence rail.
Knob
Threads
The bandsaw is one of the most versatile wood-
working machines. However, it has multiple com-
Notch
ponents that must be properly adjusted for the
best cutting results.
For practical and safety reasons, some adjust-
ments and test operations must be performed
before performing other necessary adjustments.
Below is an overview of all the adjustments and
the order in which they should be performed:
1. Blade Tracking
2. Dust Collection
3.
Test Run
4. Tension Blade
5.
Adjusting Blade Support Bearings
6. Adjusting Blade Guide Bearings
7.
Table Tilt Calibration
8.
Aligning Table
9. Aligning Fence
Fence
Lock Lever
Adjustment
Overview
G0803 (Mfd. Since 09/15)
"D" Nut
Slot
Fence Base
on Fence
Rail