Pioneer CU-RF100-U Operating Instructions Manual page 15

Controlling the rest of your system
4 Point the two remote controls towards
each other, then press the button that will be
doing the learning on this receiver's remote
control.
PRESS KEY lights continuously to indicate the
remote is ready to accept a signal.
• The remote controls should be 3 cm
(1 inch) apart.
3 cm (1 inch)
5 Press the corresponding button on the
other remote control that is sending
(teaching) the signal to this receiver's remote
control.
For example, if you want to learn the playback
control signal, press and hold  briefly. The
remote display will shows OK if the operation
1
has been learned.
If for some reasons the operation hasn't been
learned the remote display shows ERROR
briefly, and then display PRESS KEY again. If
this happens, keep pressing the (teaching)
button as you vary the distance between the
two remotes, until the remote display shows
2
OK.
Note
1 Note that interference from TVs or other devices will sometimes result in the remote control learning the wrong signal.
2 • Some commands from other remote controls cannot be learned, but in most cases the remotes just need to be
moved closer together or farther apart.
• If the remote display shows MEMORY FULL, it means the memory is full. See Erasing one of the remote control
button settings on page 16 to erase a programmed button you're not using to free up more memory (note that some
signals may take more memory than others).
• Depending on the type of command that has been learned, operation may not be possible with RF two-way
communications. In this case, operate using IR signal transmission. For instructions on switching between the IR and
RF modes, see Operating other components by RF communications on page 7.
Certain buttons represent operations that
cannot be learned from other remote controls.
The buttons available are shown below:
MAIN
RECEIVER SOURCE
ZONE2 3
MULTI
OPERATION
BDR
BD DVD DVR HDMI
NET RADIO
TV CD HMG ADAPTER
USB OPTION
iPod TUNER 1 2
MULTI CH
PHONO IN VIDEO CD-R
INPUT SELECT LIGHT
AUX
SOURCE
TV RECEIVER
CH VOL
VOL
TV CONTROL
INPUT MUTE MUTE
AUDIO VIDEO
6 To program additional signals for the
current component repeat steps 4 and 5.
To program signals for another component,
exit and repeat steps 1 through 5.
7 Press and hold MULTI OPERATION for a
couple of seconds to exit and store the
operation(s).
TV CONTROL
INPUT MUTE MUTE
AUDIO VIDEO
PARAMETER PARAMETER
TUNE
TOOLS
LIST
TOP MENU T.EDIT
BAND GUIDE
PRESET PRESET
ENTER
CATEGORY RETURN
HOME
MENU
TUNE
iPod CTRL PTY SEARCH
STATUS PHASE CTRL CH LEVEL
THX MPX PQLS MEMORY
AUTO/ALC/
STANDARD ADV SURR
DIRECT STEREO
PGM MENU
SIGNAL SEL SLEEP DIMMER AUDIO
A.ATT SBch MCACC INFO
DISP
HDMI OUT
CH
D.ACCESS CLASS
ENTER
CLR
03
15
En