Fhs Free Hand System L; Changing The Needle - Bernina L460 Instruction Manual

FHS Free hand system L 460

2
3

Changing the needle

1
2
3
Operating Instructions
The Free Hand System lever allows raising the presser foot without using the hands.
⦁ Insert the FHS lever into the FHS Connection (1).
⦁ Pushing the FHS lever to the right with the knee (2) raises the presser foot.
⦁ Wurde der Nähfuss mit dem Nähfussheber angehoben (3), kann er mit dem Kniehebel
gesenkt werden, in dem dieser ganz nach rechts gedrückt und langsam losgelassen
wird.
1
Die seitliche Position des Kniehebels kann durch ein BERNINA-Fachgeschäft
etwas angepasst werden.
1 Kneelifter Socket
2 Operating direction
3 Raising the presser foot
⦁ Lower the presser foot.
⦁ Raise the needle bar to its highest position by turning the handwheel counter-clock-
wise.
⦁ Loosen the needle set screw and remove the needle. In doing so, use the 1.5mm hex
screw driver which is provided in the looper cover.
⦁
Insert the new needle (flat side to the back) into the needle holder and push it all the
way up. Use the needle checking window (3) to check the needle position.
⦁
Tighten the set screw.
1 Set screws
2 Needle (flat side to the back)
3 Needle checking window
Use needles of the system 130/705H. „Needle and Thread" see page 18.
15