Monitoring Your Baby; Switching On The Units - Philips Dect SC479 Instructions For Use Manual

SC479_book.qxd 06-07-2004 09:55 Pagina 9
Beltclip
Connecting to the Parent Unit
1 Slide the wider side of the clip into the small rectangular recess on the
back of the Parent Unit.
Make sure the pins on the underside are above the circular recess.
2 Press the clip downwards until it clicks in position.
Disconnecting from the Parent Unit
• Press the visible pin in the circular recess upwards and lift the clip
outwards.

Monitoring your baby

Switching on the units

1 Position the Baby Unit at least one metre away from your baby.
Never place the Baby Unit inside the baby 's bed or playpen.
2 Press and hold the A button (7) on the Baby Unit to switch on the Baby
Unit.
3 Press and hold the A button (26) on the Parent Unit to switch on the
Parent Unit.
> Both displays light up and indicate the current room temperature.
> All lights light up for 2 seconds and then turn off again.
> The DECT SYSTEM LINK lights (3 and 21) of both units light up orange
then start blinking (green).The units now search for connection.
> The DECT SYSTEM LINK lights (3 and 21) of both units light
continuously (green) when the units have established connection.
You can now monitor your baby.
• To switch off the units again press and hold the A buttons (7 and 26).
> The units will beep when they are switched off.
Note:The Parent Unit beeps when it is (accidentally) switched off while
monitoring.
ENGLISH
9