Table of Contents
Advertisement
Please refer to the Supermicro web site for a list of supported memory
(www.supermicro.com/products/superblade). The detailed specifications for a blade
module will contain a link to a list of recommended memory sizes and manufacturers.
Details on installation of memory modules into the SBI-7128R-C6 blade module are
found in
Chapter 3: "Setup and Installation" on page
Storage
The SBI-7128R-C6 blade module can have six 2.5" Hot-swap HDD/SSD/NVMe SATA
(Serial ATA)/SSD hard disk drives in front-mounted easy removable carriers. Only three
of these drives can support NVMe drives. See
page 3-1
for storage installation details.
Density
A maximum of ten blade modules may be installed into a single blade enclosure. Each
blade enclosure is a 7U form factor, so a standard 42U rack may accommodate up to six
10-blade enclosures with 60 blade modules, or the equivalent of 60 1U servers. With the
inclusion of six CMM modules, twelve Gigabit Ethernet switches and six InfiniBand
switches, this would occupy up to 84U space in a conventional 1U server configuration.
3-1.
Chapter 3: "Setup and Installation" on
1-3
Chapter 1: Introduction
Advertisement
Table of Contents
