Blade Module Features; Processors; Memory - Supermicro SBI-7128R-C6 User Manual

Blade module
Hide thumbs Also See for SBI-7128R-C6:
Table of Contents

Advertisement

SBI-7128R-C6 Blade Module User's Manual
1-3

Blade Module Features

Table 1-1
lists the main features of the SBI-7128R-C6 blade module. See the
proceeding section for components typically included in a blade system and other
optional components. Specific details for the SBI-7128R-C6 blade module are found in
Chapter 4: "Blade Module Features" on page
Table 1-1. SBI-7128R-C6 Blade Module Specification Features
Mainboard

Processors

FSB Speed
Chipset
Graphics Controller
BIOS
Memory Capacity
SATA Controller
Hard Drive Bays
Processors
The SBI-7128R-C6 blade module supports dual 2011-pin (LGA 2011 Socket R3) Intel
Xeon E5-2600 v3 series processors.
Refer to the Supermicro web site for a complete listing of supported processors
www.supermicro.com/products/superblade). Please note that you will need to check the
detailed specifications of a particular blade module for a list of the CPUs it supports.
Details on installation of the processor into the SBI-7128R-C6 blade module are found in
Chapter 3: "Setup and Installation" on page

Memory

The SBI-7128R-C6 blade module has sixteen (16) 288-pin DDR4 DIMM sockets that
can support up to either 512 GB of 64 GB and 32 GB LRDIMM or 1 TB of 32 GB, 16 GB,
8 GB and 4 GB RDIMM, 2133/1866/1600 MHz speed SDRAM. Memory is interleaved,
which requires modules of the same size and speed to be installed in groups (of two or
three).
B10DRC (proprietary form factor)
Chassis Dimensions (HxWxD): 11.32"x 1.67" x20.5" (288-mm x 42.4-mm x
520.7-mm)
Dual or quad core Intel
Please refer to our web site for a complete listing of supported processors.
QPI up to 9.6 GT/s
Intel C612
Aspeed AST2400 BMC Graphics
128 MB SPI Flash EEPROM with AMI® BIOS
Supports up to 1 TB memory in 64 GB and 32 GB LRDIMM or 512 GB in
32 GB, 16 GB, 8 GB and 4 GB RDIMM size, 2133/1866/1600 MHz speed
SDRAM in sixteen (16) 288-pin DDR4 DIMM sockets
Intel C612 on-chip controller for six Serial ATA drives
Includes six hot-swap drive bays for 2.5" Hot-swap HDD/SSD/NVMe SATA
disk drives (RAID 0, 1 and 5), but only three of these drives can support
NVMe.
1-2
4-1.
®
Xeon
E5-2600 v3 series 2011-pin processors.
3-1.
(http://

Advertisement

Table of Contents
loading

Table of Contents