Furuno FCR-2127 Installation Manual page 38

2. WIRING
Cable fabrication for the cables connected to the 03P9342 board
• Signal cable RW-9600 (Between antenna unit and radar processor unit)
Vinyl sheath
Vinyl tape
Clamp here by cable clamp.
• Other cables for optional units
Use TTYCS-1 or TTYCS-1Q (Japan Industry Standard cable) or equivalent.
Armor
Wiring for WAGO connector
Wire
Twist
Procedures
1. Twist the conductor.
2. Press the terminal opener downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
5. Pull the wire to confirm that it is ecure.
2-10
Armor
60
5
After exposing cores,
wind shield around the armor.
Armor
Sheath
Shield
φ =
10.1 mm
Conductor
2
S = 0.75 mm
φ = 1.11 mm
TTYCS-1
Scrape off paint.
60
5
After exposing cores,
Vinyl tape
wind shield around the armor.
Clamp here by cable clamp.
Press downward.
Terminal opener
WAGO connector
Shield
450
6
Coaxial cable
Coaxial cable
Armor
Sheath
Shield
φ =
11.3 mm
Conductor
2
S = 0.75 mm
φ = 1.11 mm
TTYCS-1Q (Four core twisted)
Shield
L= Depends on equipment
connected. Measure at
L
the processor unit.
6
Wiring for Coaxial cable
Clamp shied with bracket.
Tighten conductor with screw.
CAUTION
Do not use crimp-on lug to prevent
contact resistance from increasing.
5 9
14
Conductor
Fold back shield.